DEP Csövek KAWASAKI 4 Ütemű KLX250 SO AC 5060630142919 DEPK4902

Gyártó:
Cikkszám:
972179
Gyári cikkszám:
DEPK4902

143920.21

113323.0000

143 920 Ft

Nettó: 113 323 Ft

DEP Csövek KAWASAKI 4 Ütemű KLX250 SO AC 5060630142919 DEPK4902

Rendelhető
Rendelhető

Product Information
DEP 4 stroke silencers and cans have been designed to improve
performance over the OE power curve, while still complying with all
worldwide noise regulations.
The DEP Silencer comes with an aluminium mounted canister with an
anodised black finish or a polished bare metal finish (depending on
models).
The majority of silencers have a unique two stage inner core design and
bleed chambered front cap. These designs allow us to maintain high
performance while keeping to current noise regulations.
Most silencers come with laser cut 1.2mm stainless wrap round mounting
brackets. These hanging brackets are designed to help with easy fitment
and allow the silencer to flex. Please see diagram for fitting advice.
For re-packing and Q-insert information, please see the link provided.

WARNING
During use exhaust systems get hot. To avoid danger of burning, do not remove or
touch until adequate cooling time has been allowed.

Fitting Instructions
Loosen all silencer mounts and remove the silencer. Repeat this for the header
pipe. Ensure the OE cylinder gasket is still located in the cylinder. Loosely fit the
DEP header using original fixing bolts/nuts. DEP Header pipes that are sprung
mounted require the header pipes stub and flange to be mounted to the cylinder
then the header engaged and sprung mounted using spring supplied. Make sure
there is clearance from frame and water hoses. Install the DEP silencer; if the
silencer is a two piece silencer join the two parts and secure with the springs
provided. Slide the silencer over the head pipe and loosely fit the front silencer bolt
using the alloy frame to silencer spacer if supplied. If your product has a fixed
silencer body bracket loosely bolt it to the sub frame. If a wrap bracket/brackets are
supplied slip it over the silencer body line with sub frame mount and place bolt in
loosely (use DEP bolt and alloy spacer sub frame side of bracket if provided)
ensure that the silencer body is up right, fit the bracket clamp bolt and then tighten,
making sure the system does not touch the frame air box side panels before
tightening all the mounting bolts.
A silencer fitted under stress can cause failure or damage to the product. DEP
cannot be held responsible for any incorrectly fitted products.
The fitting to non-original equipment or DEP equipment is the responsibility of the
end user.

Notes:
This performance product is designed to replace original equipment in some cases
it is compatible with a OE equipment but best results are obtained when used as a
full DEP system.
Jetting on new stock bikes - use standard carb settings unless otherwise stated. If
any modifications or tuning (including using non-pump fuel) are carried out, always
check plug for correct mixture settings.

When washing or cleaning the motorcycle the outlet end of the silencer should be
sealed with a bung to prevent the ingress of water. 

Cikkszám: 972179
Gyári cikkszám: DEPK4902
Állapot Új
Raktárkészlet Rendelhető

Írjon véleményt

A megtekintéshez belépés vagy regisztráció szükséges